Showing posts with label AC to DC Converters. Show all posts
Showing posts with label AC to DC Converters. Show all posts

03 October, 2007

Non-isolated Off-line AC to DC Power Supply

This compact efficient circuit can provide up to 100ma of a regulated 5 volts from an AC power source ranging from 20vac to 120vac.

MINIATURE ISOLATED AC/DC POWER SUPPLY

This circuit uses a novel approach to produce a fully isolated and regulated 5 volts @30ma from the 120vac power line. It uses two tiny SCRs that alternately discharge two capacitors through a miniature high frequency transformer. The voltage spikes produced through the transformer are rectified, filtered and regulated. A very common 8 ohm audio impedance matching transformer can be used for the transformer.

18v AC to DC Power Supply

This is a classic linear power supply which produces a regulated 18v, rated at about 1 amp.

LOW POWER 12,000 VOLT POWER SUPPLY

If you need about 12,000 volts DC for an ion generator this circuit might be the ticket. It draws power from the 120vac power line but it uses a small 6KV camera flash trigger coil. The output signal is isolated from the power line. Although the circuit can only deliver about 5uA of current it can produce dangerous shocks, so be careful.

ISOLATED AC CURRENT MONITOR

This circuit uses a small AC current transformer from Magnetek to produce an isolated voltage proportional to the AC current in the primary winding. The transformer contains a single turn primary with a low 0.001-ohm resistance. It can easily handle 30 amps of AC current and provides at least 500vac of isolation. With the components shown, the output AC voltage is scaled so 1 amp of current produces 100mv of AC voltage.

Classic Plus and Minus DC Power Supply

This is a classic example of a regulated DC power supply that produces both a positive 15v and a negative 15v from a 20vac wall adapter.

CAPS PROVIDE VOLTAGE BOOST TO SERIES REGULATOR

This circuit adds some capacitors and diodes to a traditional transformer type series regulator circuit to extend the normal operating range. It can insure regulation during low line voltage conditions or it can squeeze a few more watts out of a plug-in-the-wall power adapter power supply.

240VAC TO 5VDC POWER SUPPLY

This is simple way to power some 5v logic from a 240vac source. If a 120vac power adapter is used, the circuit will also work for 120vac power lines.